11
Figure 14: TYSSO MSE-700 Utility: Main Menu – Copy (Write Target)
The utility will loop continuously on the Copy Read – Copy Write cycle until you exit the
operation.
In case of an unsuccessful read (from source) or write (to target), the utility will report
the error and prompt you to retry as depicted below:
Figure 15: TYSSO MSE-700 Utility: Copy Read Swipe Error
12
Figure 16: TYSSO MSE-700 Utility: Copy Write Swipe Error
Erase Operation
Erase operation enables you to remove unwanted tracks from an old card. Note that
Write operation only overwrites the tracks as enumerated by the source data. Therefore,
you are able to modify track 1 and leave tracks 2 and 3 unchanged for an existing triple-
track card. You will need to manually erase the tracks that are no longer required. For
instance, in case you want to convert a triple-track card to a tracks 1&2 card, you can first
erase track 3 and then rewrite tracks 1&2, or vice versa.
When you click on the Erase button, the utility will prompt you to select the track(s) to
erase:
Figure 17: TYSSO MSE-700 Utility: Erase – Track Selection
The utility then prompts you to swipe a card to erase.
13
Figure 18: TYSSO MSE-700 Utility: Erase Swipe Prompt
You may continue to erase more cards with the same track selection until you cancel the
operation.
In case of an unsuccessful erase of any kind, the utility reports the error and prompts you
to try again:
Figure 19: TYSSO MSE-700 Utility: Erase Swipe Error
Encode from File Operation
Encode from File enables you to encode multiple cards from a previously created text
file. When you click on the Encode from File button, the utility puts up the “Open –
Look in:” window for you to locate a source a file to encode.
Swipe Card Reader |
ISO & JIS-II combo | Dual Side |
Barcode Magstripe Combo |
Encoder |
OEM Module |
Portable Magstripe
| FAQ
Barcode Scanner |
Magstripe Card Reader / Writer |
POS Customer Display |
POS Keyboard
Touchscreen POS System |
Cash Drawer |
Serial-Ethernet Converter
14
Figure 20: TYSSO MSE-700 Utility: File Encode – Open – Look in
The utility checks the format of the source file and reports any non-ASCII format as an
error:
Figure 21: TYSSO MSE-700 Utility: File Encode – File Format Error
Please note the following when manually creating a text file for use with File Encode:
· Each record should follow the “Track 1 Data|Track 2 Data|Track 3 Data” format, such
as “THIS IS TRACK ONE DATA|2222222222|01234567890123456789”.
· Use “|” as track separator and include two separators for each record with or without
empty track(s). For instance, a track 3 only record will look like “||33333333”. Do
15
not separate the tracks of the same record into multiple lines by inserting the “Enter”
key.
Upon successful open of a source file, the utility enters the first valid record into the input
record window
Figure 22: TYSSO MSE-700 Utility: Main Menu – Encode from File (Read Record)
then prompts you to write to a target card:
Figure 23: TYSSO MSE-700 Utility: File Encode Prompt – Write Record
