5V-DC power-jack (on the RS-232 cable-end):
RS-232 connector:
1. Single Track:
2. Dual Track:
3. Triple Track:
Notes:
To be connected with 5V-DC power
adapter.
(Inner pin is positive)
Note: 9V-DC power input model should
request to supplier.
D-Sub 9 pin Female
Pin
2 3
5 9
Wire
Red White
Yellow Black
Function
TX GND
VCC
SS
Card Data ES
SS
Track 1 or 3 Data ES
SS
Track 2 Data ES
SS
Track 1 Data ES
SS
Track 2 Data ES
SS
Track 3 Data ES
1) SS (Start Sentinel):
% for Track 1
; for Track 2 or 3
2) ES(End Sentinel):
? for Track 1, 2 or 3
3)
(Carriage Return):
Carriage Return can be set by Left-SW-7
4) Selectable setting for SS, ES and
7. NORMAL OUTPUT DATA
FORMAT
Decoded MSR Series
User's Manual
4
5
1.
Introduction.................................................... 1
2.
Features........................................................ 1
3.
Specifications................................................ 1
4. LED
Indicators.............................................. 1
5. Switch
Settings............................................. 2
6. Installation
Steps........................................... 4
7. Normal Output Data
Format........................ 5
Contents
MAGNETIC STRIPE CARD READER
6. INSTALLATION STEPS
1. For Keyboard Wedge Reader
2. For USB Reader
3. For RS-232 Serial Reader
Step 1
Turn the computer system power off, and unplug the
keyboard cable.
Step 2
Connect the keyboard cable into the short-cable of the
Reader.
Step 3
Connect the long-cable of the Reader into the keyboard
input socket on the computer system.
Step 4
Turn the computer system power on, then you can hear
a beep sound for confirming the reader's
self-test, and
Green LED will be lit to indicate that
the Reader is
ready for reading.
Step 1
To make sure the Windows USB utility is available in
your computer.
Step 2
Connect the MSR's USB cable to the USB port on the
computer, the Green LED will be lit to
indicate the
MSR is ready for operation.
Step 1
Turn the computer system power off.
Step 2
Connect the Reader's cable to the RS-232 port on the
computer system.
Step 3
Connect the DC power adapter to the power-jack on the
cable-end of the Reader, then plug the
adapter into AC
socket. You can hear a beep sound for
confirming the
Reader's self-test, and Green LED will
be lit to indicate
that the Reader is ready for reading.
Step 4
Turn the system power on, and run your application
software, include one driver utility, to
get the data from
the serial port which connects with the
Reader.
to PC Keyboard port
to Keyboard
to USB port
AC power
source
RS-232 port
+
GND
9
5
6
1
MSR-
Color
Interface:
Track:
: M (beige)
B (black)
K (Keyboard)
R (RS-232)
U (USB)
01 (track 1)
02 (track 2)
03 (track 3)
12 (track 1&2)
23 (track 2&3)
33 (track 1&2&3)
40 (JIS-2)
Custom Designed Card Readers are
available.
