B. DSP-400 DOS version configuration
software:
1. Run "Your_CD-ROM: \
Configuration_Utilities \ DSP-400
\ DSP-DOS \ DSP-400.exe" to setup the
customer display's
RS-232 communication under DOS mode
2. Then, follow this menu to run the
utility.
Press F1 to set RS-232 communication of
the computer,
select COM port. Baud rate must be set as
the same as the
baud rate shown on the lower line of the
display, such as
"9600 N 8 1" means baud rate 9600, No
Parity, 8 data bits,
and 1 stop bit.
Press F2 to set RS-232 communication of
Display, select
Baud rate and Parity must be No Parity.
Also the
selections at F1 and F2 must be the same,
otherwise
Display can not communicate with the
computer.
F3 to select International Character Code
Set.
(Not support in LCD display, only
available in VFD
display. )
Press F4 to save the current view message into the
memory of Display
Press F5 to move the cursor position.
Press F6 to clear some or all the current
view
message.
Press F7 to display the previously saved
message.
Press F8 to transmit the current view
message to the
computer.
After the handshaking between Display and
the computer is
completed, this means the operations F1
and F2 have
successfully been done, the Display would
display any
message character from the computer. Any
new message
from the computer would cover the old
message on the
display. You may enter any message to
display.
C.
-18-
-19-
Page Index: 1
2 3
4 5
6 7
8 9
10
11
12 13
14 15
16 17 >
Download PDF version
::
Customer Display FAQ
:: Specifications ::
Software Download
Customer Display
Index:
VFD |
LCD |
Arabic & Chinese Display |
Double Side Display
TYSSO Product Links:
Barcode Scanner |
Magstripe Card Reader
/ Writer |
POS Customer Display |
POS Keyboard
Touchscreen POS System
| Cash Drawer |
Serial-Ethernet
Converter | Links to Other Sites
Home
| Contact
