Manufacturer of POS Systems: POS-5000 User's Manual

2. Operating System

The POS System 5000 main board is compatible with Windows 95/98/2000/XP and Red Hat Linux 9.0. If the drivers are required, find the necessary files in the bundled CD. The storage media can be HDD, Compact Flash (CF), or Disk on Module (DOM) depending on different options.

2.1 Install OS by External CD-ROM

a. Connect an external CD-ROM to the POS system as the figure shown below and insert the installation CD for the Operating System.

b. Press the <Delete> key after powering on the POS system. The system will enter the BIOS Setup Utility.

c. Select “Boot” with the key. Select “Boot Device Priority” with the key and press the <Enter> key.

d. Select “1st Boot Device” and press the key. Press the key to select “USB: External CD-ROM.” Press the <F10> key to save and exit the setting.

e. After the POS system reboots, it will start to install the operating system from the CD.

2.2 Adjust System Fan Mode and Brightness

a. Press the <Delete> key after powering on the POS system to enter the BIOS Setup Utility.

b. Select “Advanced” and then “Harware Health Configuration”. Press the <Enter> key to go to the sub screen.

c. Select “System Fan Mode” and press the <Enter> key. There are 3 modes for options:

Full On mode makes the system fan run at its full speed.
Automatic mode is not available.
PWN Manually mode enables the users to adjust the system fan by entering a number between 20~127. The higher the value, the higher the speed will be.

d. Select “PWM Duty control.” Adjust the brightness by entering a number ranges from Min 20 to Max 127. The higher the value, the brighter the screen will be.

e. After configuring the setting, press the <F10> key to save and exit the setting. The system will reboot automatically.