2. Components
& Peripherals Installation
2.1 Replace Hard Disk
 |
Lift the cover from the upper side edges as marked by the
circles and push it down to remove it. |
|
 |
Lossen the screw x 4 on the VESA bracket. |
|
 |
Turn over the system to loosen the screw x 2 on
the back of the panel. |
|
 |
Remove the panel from the VESA bracket. |
|
 |
Loosen the screw on the cover of the hard disk
bay to remove the cover. |
|
 |
Loosen the spacer. |
|
 |
Hold the hard disk and take it out in the
direction. Then unplug it from the connector. |
|
 |
Loosen the 4 screws to remove the hard disk from
the bracket. Then install the new hard disk following the above
steps with the order reversed. |
2.2 Install Second Display
|
 |
Hold the second display and turn the system over
carefully. Pass the cord through the holes in the directions of
the arrows. Plug the cable into the VGA port and connect the
extension power cable. |
|
 |
Tighten the bundled screws specified for the
stand of the second display to fix it to place. |
2.3 Install Pole-type Customer Display
|
 |
Pass the cord of the customer display through the holes in the
directions of the arrows. Plug the cable to a free COM port and
connect the extension power cable. |
|
 |
Press the stand of the customer display into place. |
Note
l
The rear top mount customer display is pre-installed in
factory.
l
If the 9th pin of the RS-232 connector is power in, the
device can be powered directly via the COM port by jumper setting (see
“POWER COM Jumper Setting” in Section 1.3 I/O Ports and “JP10: COM1,
COM2, COM4 port RI and voltage selection” in Section 6.1 Jumper
Settings). Thus the extension power cable is not necessary.
Other POS Terminals
