Tysso Dot-Matrix Receipt Printer

-17- -16- 2. CONFIGURATION 2.1) Interface 2.1.1) RS-232 serial interface 2.1.1.1) RS-232 Specifications Data transmission: Serial Synchronization: Asynchronous Handshaking: DTR/DSR or XON/XOFF control Signal levels: MARK = -3 to -15 V: Logic "1"/ OFF SPACE = +3 to +15 V: Logic "0"/ ON Baud rate: 9600, 19200 bps Data word length: 8 bits Parity Settings: None Stop bits: 1 or more Connector : Female DSUB-25 pin connector (printer side) NOTE: The data word length, baud rate, and parity depend on the DIP switch settings. The stop bit for the printer side is fixed to 1. 1.8) Environmental Conditions 1.9) Installation 1) Temperature: Operating: 0 to 50C (41 to 113F) Storage: -10 to 60C (14 to 122F) (except paper) 2) Humidity: Operating: 10 to 80% RH Storage: 10 to 90% RH (except for paper) 3) Acoustic noise (Operating): When using auto cutter Approximately 50 dB (Bystander position) When not using auto cutter: Approximately 40 dB (Bystander position) 1) The PRP-076 series printer must be installed horizontally. (Vibration during paper cutting and using a drawer should be considered. Take measures to prevent the printer from moving. Affixing tapes are provided as an option.) An optional hanging bracket can attach the printer to a wall. (Following the procedures describes in the installation manual, install the wall mount and change the location of the paper roll near-end sensor, then install the paper roll stopper and other parts.) NOTE: If the printer is not used for a long time with paper installed, some part of the printing may be light due to the deformation of the paper. If the printer is not used for a long time with paper installed, be sure to feed paper approximately 30 mm before printing

Page Index [1] [2] [3] [4] [5] [6] [7] [8] [9] [10] [11] [12] [13] [14] [15] [16] PDF Version

POS Printer Index | User's Manual | Specification | Product Index