Tysso Dot-Matrix Receipt Printer

-4- -5- 2.2) Loading the Paper Roll and Ink Ribbon a. Make sure that the paper roll matches the printer's specification. Do not use paper rolls that have the paper glued to the core because the printer cannot detect the paper end correctly. Important: The printing quality and lifespan of the printer head cannot be guaranteed if any paper other than that recommended is used. Thus, the warranty will be void automatically if any fault occurs due to the use of wrong paper rolls. b. Open the top cover c. Install the paper roll as the picture showing direction d. Pull the paper out of some length to outside, then close the cover. e. Open the printer's cover, turn the knob five or six times in the direction of the arrow, insert the ink ribbon, and push the ribbon cassette down until it clicks. Important: Do not open the printer cover when printing is in progress. 3. Printer Interface and Connection 3.1) Connecting the Interface Cable Printer Interface: a) Before connecting/disconnecting the interface cable, make sure that power to the printer and all the devices connected to the printer is turned off. b) Connect the interface cable to the connector on the rear panel of the printer. c) In the case of a serial interface, tighten the connector screws. In the case of a parallel interface, fasten the connector clasps.

Page Index [1] [2] [3] [4] [5] [6] [7] [8] [9] [10] [11] [12] [13] [14] [15] [16] PDF Version

POS Printer Index | User's Manual | Specification | Product Index