Page Index:
1
2
3
4
5
6
7
Download:
PDF Manual
|
Java Based Setup Utility |
Latest Firmware Patch
|
Virtual COM Port Driver
See Also:
eCOV-100 Basic Model.,
eCOV-132X Box Model, and eCOV-432
Server Model
Serial-Ethernet Converter FAQ
Barcode Scanner | Magstripe Card
Reader / Writer
|
POS Customer Display |
POS Keyboard
Touchscreen POS System | Cash Drawer
|
Serial-Ethernet Converter |
Receipt
Printer
CI
TCP Client
Destination IP
S, G
Format :xxx.xxx.xxx.xxx
CP
TCP Client
Destination Port
S, G
Available range: 0~65535
CC
TCP Client
Connecting at
S, G
0 : After ADSL connected
1 : While serial data
arrived
UDP Transfer Settings
UI
UDP Destination IP
S, G
Format:xxx.xxx.xxx.xxx
UP
UDP Destination
Port
S, G
Available range: 0~65535
UL
UDP Local Listen
Port
S, G
Available range: 0~65535
Exit Command Mode
YC
System Call
S Only
Available parameter:
“R”: Restart eCOV-110
“D”: Reset to factory
default value
“S”: eCOV-110 enter
software upgrade status
EI
Exit Only
S Only
No parameter required.
Exit Command Mode
directly and Back to data
transfer mode without
restarting the eCOV-110
unit.
Ø Notes:
l Always
use uppercase letter for Serial Command inputs.
l All
parameters that been saved to eCOV-110 after setting, will need to be restarted
with the eCOV-110 unit to enable its
functions.
l Not
all OP Code can be set and loaded for bidirectional operation.
4.4.Command Mode operation example
The following example shows how to operate in
network terminal (refer section 4.1) and use the
Command to change the IP address of eCOV-110
unit.
Ø Enter
Command Mode
l At
HyperTerminal select ”TCP/IP (Winsock)”
l Enter
the IP address of eCOV-110 and the specific Port No. 5001 for eCOV-110.
l Type
the Command “$LOG” to enter Command Mode
Ø Change
the IP Address
l Load
the original LAN IP
l Execute
the LAN IP change
l Check
to see if the IP has been changed, and input Command “YCR” to restart the
eCOV-110 unit.
Ø Use
the ping command to check if the IP has been changed successfully.
5. Connection
Test 5.1.Environment Setting
Ø Connect
eCOV-110-EV Serial interface with PC COM Port through RS-232 NULL
Modem.
Ø Connect
eCOV-110-EV with PC through Ethernet Switch or Cross-Over Cable in the same
LAN.
Ø Plug
in the eCOV-110-EV Power Adaptor
eCOV-110: 5V~9V DC, >300 mA
5.2.Firmware
Ø Using
HyperTerminal for serial interface equipment reception simulation.
Ø Using
HyperTerminal for TCP Client orders at Host PC side.
5.3.Setup eCOV-110
Ø Serial
port parameter: RS-232, 9600 bps, N-8-1
Ø LAN
parameter: 192.168.2.127
Ø TCP
Server parameter: Listen Port 4000
Ethernet Switch
Host PC
eCOV-110-EV
RS-232 Cable
COM
Port
Ethernet
Port
Ethernet
Cable
5V Power Adaptor
5.4.Setup the first HyperTerminal program for
equipment simulation (9600 bps, N-8-1, None Flow
Control)
